Monome 40h BOM and build guide maybe?

Hi, I had this 40h pcb and logic board (and gummi pads) laying around for many years, decided to build it but cannot find the BOM for the LED board, I assume its just LEDs and a diode or resistor or something?
Im also curious about the location for the flat cable connector as the gumi pad ends up resting half over it, do I need to cut the edges of the gummi pad or?

is this what you’re looking for?

2 Likes

Hmm, but what about the LEDs?

They should be pretty standard 3mm LED’s. At least that’s what I remember what I used on mine.

EDIT: Also pretty sure the forward voltage was 2.2V… but I don’t think it’s crucial.