#164

yes it has a screen interface— but there might be an error in the script. i need to check it out.

2 Likes
#165

new disk image is in the top post. confirmed working with CM3+

8 Likes
#166

Wunderbar!

Does this need an additional step to make full use of the extra disk space, or does the full disk image take care of that as well?

#167

this is sort of a meta norns post, but would it be beneficial to set up the full image download using bittorrent? I know I wouldn’t mind seeding if it helped ease bandwith issues.

2 Likes
#168

I can probably host it in my G-Drive as well. If needed.

#169

There’s no automatic “expansion” at the moment, but the steps are pretty simple Norns 2.0 beta

2 Likes
#170

has anyone updated the Haven script of Lfsaw to 2.0 version?

1 Like
#171

Oh yeah! I’d love to use it again! @LFSaw do you plan to update it? :slight_smile:

1 Like
#172

unfortunately i do not own a norns myself so am depending on others here… i’ll investigate though and will post here.

(in case you’d like to sponsor a norns for further development, i am happy to provide you with my postal address :stuck_out_tongue: )

2 Likes
#173

I can update Haven. I believe I get the time later today.

2 Likes
#174

Would you be OK with moving haven to it’s own repo? We’re trying to move all scripts and engines out of the we repo.

1 Like
#175

sure, whatever it takes

#176

Haven was really simple, just required a oneliner fix for reverb input level. FYI, I posted an updated version as a gist here: https://gist.github.com/antonhornquist/83f074dfa5b27478895cc9a776cc7518

(hope that’s okay)

…the engine is already included in the we repo.

3 Likes
#177

if you could tell me what needs to be done, i am happy to set up the repo accordingly in my github account and would then accept PRs.

#178

I’ll send you a PM :slight_smile:

1 Like
#179

ok…also midi params are unresponsive… doesi t only sample when the rate is around 1? thanks

#180

I installed the CM3+ and got the image onto Norns fine, it boots fine, I did not break anything as well. Yay!!!

However I am lost with how to expand the disc usage of CM3+
What does this mean:

"to expand disk

sudo raspi-config

advanced > expand disk

reboot"

How do I do this? With the switch set to disk or to run?

I tried and I got an sudo: raspi-config: command not found

Thanks for helping me with this last step again.

(A few minor steps were missing in the scattered information, eg I did not have wget installed and needed to run brew install wget, also I had to run tar xzf norns190405.tgz to get the image file as I simply guess that .tgz would not be a valid file for an image)

2 Likes
#181

Should be similar to this article, although I haven’t personally done it on Norns:

Are you saying that running running ‘sudo raspi-config’ via command line gives you that message?

1 Like
#182

Connect Norns to the internet.
Note your Norns ip address.
On your computer, I assume it’s a mac, open a terminal.
Type ssh we@(your norns ip address)
The password will be sleep.
You should now be connected to Norns!
run sudo raspi-config etc…

Hope this helps!

5 Likes
#183

hi, thanks but @Justmat helped me with the info that I need to ssh…

All running now… Thanks a lot!
:partying_face:

2 Likes