I need to get the shnth back out and do some tutorial type videos I’ve got some time coming up
I haven’t done anything with it for a while but I believe if you have a jump mul’d to 1 whatever was triggering that jump would jump by 1 each time it is triggered.
I don’t remember it wrapping around unless you where to use one of the wrapping opcodes
or you could use a wheel and have another value the also decreased the jump by one to get back to the previous patch
as long as a bar press is MUL’d down low you can absolutely switch between a small amount of patches that could then be offset by another button (tar) press which would select between another set of patches
using the LED opcode could be nice for some feedback maybe from the MUL’d bar plus offset combination or just the MUL’d bar
if you where only switching between two sets of 4 subpatches
you could ADD a TOGGLE triggered by TAR MUL’d to 4 and a bar MUL’d to 4
ADD the above with 1 and then put that inside the jump that should give 1-4,5-8
if you want to switch between more subset than that you would have to think about how you want to navigate between them
do you want to have to press multiple buttons at the same time to pop into a subset of patches to play in where no held buttons would most likely represent patches 1-4 and two held buttons could represent patches 13-16
do you want toggled behavior where a trigger would leave you on a subset of patches
would you want to just increment through the patches? increment and decrement? choose randomly? choose randomly and also change the range of patches to be expressed through the BAR pressure?
I miss playing with this even more now I think I’ll pop it on the charge tonight
I’ve thought about two of the V2 shnths for stereo processing for a long time but I’m still holding out for an oval (or anything frankly) format stuber which was briefly talked about on his website
hope this helps keep asking away
